Rohde & Schwarz R&S RTB2004 - Applications; Mask Testing

Remote Control Commands
R&S
®
RTB2000
323User Manual 1333.1611.02 ─ 04
15.8 Applications
15.8.1 Mask Testing
15.8.1.1 Mask Setup
MASK:STATe................................................................................................................ 323
MASK:SOURce............................................................................................................. 323
MASK:CHCopy..............................................................................................................323
MASK:YPOSition........................................................................................................... 323
MASK:YSCale............................................................................................................... 324
MASK:XWIDth...............................................................................................................324
MASK:YWIDth...............................................................................................................324
MASK:SAVE..................................................................................................................324
MASK:LOAD................................................................................................................. 324
MASK:STATe <State>
Turns the mask test application on or off. When turning off, any temporarily stored
masks are deleted.
Parameters:
<State> ON | OFF
*RST: OFF
MASK:SOURce <Source>
Defines the channel to be compared with the mask, and also the channel from which
the mask is created.
Parameters:
<Source> CH1 | CH2 | CH3 | CH4
CH3 and CH4 are only available on 4-channel models.
*RST: CH1
MASK:CHCopy
Creates a mask from the envelope waveform of the source set with MASK:SOURce.
Usage:
Event
MASK:YPOSition <Yposition>
Moves the mask vertically within the display.
Applications