Rohde & Schwarz R&S RTB2004 - FFT Analysis

Remote Control Commands
R&S
®
RTB2000
327User Manual 1333.1611.02 ─ 04
MASK:RESet:COUNter
Sets the counters of passed and failed acquisitions to Zero.
Usage: Event
MASK:COUNt?
Returns the number of tested acquisitions.
Return values:
<TotalCount> Total number of tested acquisitions
Usage: Query only
MASK:VCOunt?
Returns the number of acquistions that hit the mask.
Return values:
<ViolationCount> Total number of violations
Usage: Query only
15.8.1.4 Mask Data
Use the following commands that are described in Chapter 15.9.1.4, "Masks",
on page 345:
●
MASK:DATA? on page 345
●
MASK:DATA:HEADer? on page 346
●
MASK:DATA:XINCrement? on page 347
●
MASK:DATA:XORigin? on page 347
●
MASK:DATA:YINCrement? on page 348
●
MASK:DATA:YORigin? on page 348
●
MASK:DATA:YRESolution? on page 349
15.8.2 FFT Analysis
● General Settings................................................................................................... 327
● Frequency Settings............................................................................................... 330
● Waveform Settings................................................................................................331
15.8.2.1 General Settings
SPECtrum[:STATe]........................................................................................................ 328
SPECtrum:SOURce....................................................................................................... 328
SPECtrum:FREQuency:WINDow:TYPE........................................................................... 328
Applications