Network Connections and Remote Operation
R&S
®
RTB2000
158User Manual 1333.1611.02 ─ 04
11.3 Remote Access Using a Web Browser
The R&S RTB2000 firmware contains a web server. If a LAN connection is estab-
lished, you can access the instrument remotely using a web browser on the control
computer.
The browser access allows you to:
●
Check instrument data
●
Control the instrument remotely
●
Print screenshots
●
Send remote commands
●
Save waveform and instrument data
●
Check network settings
11.3.1 Accessing the Instrument Using a Web Browser
To access the R&S RTB2000, you need a LAN connection and the IP address of the
instrument.
1. Obtain the IP address of the R&S RTB2000:
● Tap the green network icon in the top right corner of the screen.
● "Setup" menu > "Interface" > "Ethernet" > "Parameter" > "IP".
2. Open an Internet browser on the control computer.
3. Enter the IP address of the R&S RTB2000 in the address line:
http//:xxx.yyy.zzz.xxx.
The "Instrument Home" page opens.
11.3.2 Instrument Home
The "Instrument Home" page provides information on the instrument and the LAN con-
nection.
Remote Access Using a Web Browser
To Next Page
Loading...
