Rohde & Schwarz R&S RTB2004 - General; Serial Bus Analysis

Remote Control Commands
R&S
®
RTB2000
370User Manual 1333.1611.02 ─ 04
Parameters:
<Polarity> POSitive | NEGative
*RST: POS
15.11 Serial Bus Analysis
● General................................................................................................................. 370
● SPI and SSPI (Option R&S RTB-K1)....................................................................372
● I²C......................................................................................................................... 383
● UART (Option R&S RTB-K2)................................................................................ 394
● CAN.......................................................................................................................401
● LIN (Option R&S RTB-K3).................................................................................... 417
15.11.1 General
BUS<b>:TYPE...............................................................................................................370
BUS<b>:STATe.............................................................................................................370
BUS<b>:FORMat...........................................................................................................371
BUS<b>:LABel.............................................................................................................. 371
BUS<b>:LABel:STATe................................................................................................... 371
BUS<b>:DSIGnals......................................................................................................... 371
BUS<b>:DSIZe..............................................................................................................371
BUS<b>:POSition.......................................................................................................... 372
BUS<b>:RESult.............................................................................................................372
BUS<b>:TYPE <Type>
Defines the bus or interface type for analysis. All buses require special option to the
instrument.
Suffix:
<b>
.
1 | 2
Parameters:
<Type> PARallel | CPARallel | I2C | SPI | SSPI | UART | CAN | LIN
*RST: PARallel
BUS<b>:STATe <State>
Switches protocol decoding on or off.
Suffix:
<b>
.
1 | 2
Parameters:
<State> ON | OFF
*RST: OFF
Serial Bus Analysis