Rohde & Schwarz R&S RTB2004 - Cursor Measurements

Remote Control Commands
R&S
®
RTB2000
317User Manual 1333.1611.02 ─ 04
REFLevel:RELative:MIDDle <MiddleLevel>
Set the middle reference level that is used for phase and delay measurements, if
REFLevel:RELative:MODE is set to USER. The level is defined as percentages of
the high signal level. The setting is valid for all measurements.
Parameters:
<MiddleLevel> *RST: 50
Default unit: %
15.7.3 Cursor Measurements
15.7.3.1 Cursor Settings
CURSor<m>:AOFF........................................................................................................ 317
CURSor<m>:STATe.......................................................................................................317
CURSor<m>:SOURce....................................................................................................318
CURSor<m>:FUNCtion...................................................................................................318
CURSor<m>:TRACking[:STATe]..................................................................................... 319
CURSor<m>:X1Position................................................................................................. 319
CURSor<m>:X2Position................................................................................................. 319
CURSor<m>:Y1Position................................................................................................. 319
CURSor<m>:Y2Position................................................................................................. 319
CURSor<m>:YCOupling................................................................................................. 320
CURSor<m>:XCOupling................................................................................................. 320
CURSor<m>:SWAVe..................................................................................................... 320
CURSor<m>:SSCReen.................................................................................................. 320
CURSor<m>:TRACking:SCALe[:STATe].......................................................................... 320
CURSor<m>:SPPeak<n>................................................................................................321
CURSor<m>:SNPeak<n>............................................................................................... 321
CURSor<m>:AOFF
Switches the cursor off.
Suffix:
<m>
.
1, the suffix is irrelevant.
Usage: Event
CURSor<m>:STATe <State>
Activates or deactivates the cursor measurement.
Suffix:
<m>
.
1, the suffix is irrelevant.
Measurements