Rohde & Schwarz R&S RTB2004 - Page 329

Remote Control Commands
R&S
®
RTB2000
321User Manual 1333.1611.02 ─ 04
Parameters:
<State> ON | OFF
ON
Cursor lines keep their relative position to the waveform.
OFF
Cursor lines remain on their position on the display if the scaling
is changed.
*RST: OFF
CURSor<m>:SPPeak<n>
CURSor<m>:SNPeak<n>
Set the cursor line to the previous / next peak, respectively. The command is only
available for FFT waveforms.
Suffix:
<m>
.
1, the suffix is irrelevant.
<n> 1..2
Selects the cursor line.
Usage: Event
15.7.3.2 Cursor Measurement Results
To get the measurement values of vertical cursor lines (time, frequency for FFT), use:
●
CURSor<m>:X1Position on page 319
●
CURSor<m>:X2Position on page 319
To get the measurement values of horizontal cursor lines (voltage, current, level for
FFT), use:
●
CURSor<m>:Y1Position on page 319
●
CURSor<m>:Y2Position on page 319
CURSor<m>:RESult?.....................................................................................................321
CURSor<m>:XDELta[:VALue]?....................................................................................... 322
CURSor<m>:XDELta:INVerse?....................................................................................... 322
CURSor<m>:YDELta[:VALue]?....................................................................................... 322
CURSor<m>:YDELta:SLOPe?.........................................................................................322
CURSor<m>:RESult?
Returns the measurement result. Make sure to set CURSor<m>:FUNCtion correctly.
Suffix:
<m>
.
1, the suffix is irrelevant.
Return values:
<Value> Measurement result
Usage: Query only
Measurements