Rohde & Schwarz R&S RTB2004 - Settings for Reference Waveforms

Waveform Analysis
R&S
®
RTB2000
76User Manual 1333.1611.02 ─ 04
6.3.2 Settings for Reference Waveforms
► To open the "References" menu:
a)
Tap the
menu icon in the lower right corner of the screen.
b) Scroll down. Select "References".
Source...........................................................................................................................76
Reference......................................................................................................................76
Copy..............................................................................................................................77
State..............................................................................................................................77
Load Reference.............................................................................................................77
Load Setup....................................................................................................................77
Save Reference............................................................................................................ 77
Waveform Color............................................................................................................ 77
Source
Defines the source of the reference waveform. Any active channel, math or reference
waveform can be selected.
Remote command:
REFCurve<m>:SOURce on page 279
REFCurve<m>:SOURce:CATalog? on page 279
Reference
Selects one of the four possible reference waveforms.
Reference Waveforms