Documenting Results
R&S
®
RTB2000
132User Manual 1333.1611.02 ─ 04
Tap "Save" to start writing the data.
Remote command:
MMEMory:STORe:STATe on page 358
Load
Opens a file explorer to select an instrument setup file to be loaded to the instrument.
To change the storage location, select "Destination" > "Location".
Tap "Load" to change the settings.
Remote command:
MMEMory:LOAD:STATe on page 358
Import Export
Opens a menu to copy data between the instrument's internal storage "/INT/
SETTINGS" and a USB flash drive.
Make sure that the USB flash drive is connected.
See Chapter 9.6, "Export and Import", on page 140 for a procedure description.
Memory Usage
Shows free memory space (absolute and relative) in the instrument's internal storage "/
INT" and used space per subdirectory in kbyte.
If a USB flash drive is detected, the free memory space in this device is also shown.
Factory Default
Resets the instrument to the factory settings.
Remote command:
SYSTem:PRESet
9.2 Exporting Waveforms
Waveform data is always saved to USB flash drive. The waveform export provides the
following possibilities:
●
Store either one waveform or all active waveforms.
●
Option R&S RTB-K15: Save history data.
●
Option R&S RTB-B1: Save logic channels.
To save waveforms:
1. Activate the waveforms that you want to export.
2. Press the SAVE LOAD key.
3. Select "Waveforms".
4. Adjust the settings in the dialog box.
5. Tap "Save".
Exporting Waveforms
To Next Page
Loading...
