Rohde & Schwarz R&S RTB2004 - Waveform Data

Remote Control Commands
R&S
®
RTB2000
265User Manual 1333.1611.02 ─ 04
ACQuire:POINts:ARATe?
Retrieves the sample rate of the ADC, that is the number of points that are sampled by
the ADC in one second.
Return values:
<ACDsampleRate> ADC sample rate
Default unit: Hz
Usage: Query only
ACQuire:SRATe?
<SampleRate>
Returns the sample rate, that is the number of recorded waveform samples per sec-
ond.
Parameters:
<SampleRate> Default unit: Sa/s
Usage: Query only
15.4.7 Waveform Data
Use the following commands are described in Chapter 15.9.1.1, "Analog Channels",
on page 338:
●
FORMat[:DATA] on page 339
●
CHANnel<m>:DATA? on page 340
●
CHANnel<m>:DATA:HEADer? on page 341
●
CHANnel<m>:DATA:POINts on page 341
●
CHANnel<m>:DATA:ENVelope? on page 342
●
CHANnel<m>:DATA:ENVelope:HEADer? on page 343
●
CHANnel<m>:DATA:XINCrement? on page 347
●
CHANnel<m>:DATA:XORigin? on page 347
●
CHANnel<m>:DATA:YINCrement? on page 348
●
CHANnel<m>:DATA:YORigin? on page 348
●
CHANnel<m>:DATA:YRESolution? on page 349
●
CHANnel<m>:DATA:ENVelope:XINCrement? on page 347
●
CHANnel<m>:DATA:ENVelope:XORigin? on page 347
●
CHANnel<m>:DATA:ENVelope:YINCrement? on page 348
●
CHANnel<m>:DATA:ENVelope:YORigin? on page 348
●
CHANnel<m>:DATA:ENVelope:YRESolution? on page 349
Waveform Setup