Remote Control Commands
R&S
®
RTB2000
343User Manual 1333.1611.02 ─ 04
To set the export format, use FORMat[:DATA].
To set the range of samples to be returned, use CHANnel<m>:DATA:POINts.
Suffix:
<m>
.
1..4
Selects the input channel. The number of channels depends on
the instrument.
Parameters:
<EnvelopeData> List of values according to the format settings - the voltages of
the envelope points. The list contains two values for each sam-
ple interval.
Usage: Query only
CHANnel<m>:DATA:ENVelope:HEADer?
Returns information on the envelope waveform.
Use this command only for envelope waveforms. for all other channel waveforms use
CHANnel<m>:DATA:HEADer?.
Table 15-2: Header data
Position Meaning Example
1 XStart in s -9.477E-008 = - 94,77 ns
2 XStop in s 9.477E-008 = 94,77 ns
3 Number of samples 120000
4 Number of values per sample interval. For envelope
waveforms the value is 2.
2
Suffix:
<m>
.
1..4
Selects the input channel. The number of channels depends on
the instrument.
Parameters:
<EnvelopeHeader> Comma-separated value list
Example: -9.477E-008,9.477E-008,200000,2
Usage: Query only
15.9.1.2 Math Waveforms
In addition to the commands described below, consider also the following commands:
●
CALCulate:QMATh:DATA:XINCrement? on page 347
●
CALCulate:QMATh:DATA:XORigin? on page 347
●
CALCulate:QMATh:DATA:YINCrement? on page 348
●
CALCulate:QMATh:DATA:YORigin? on page 348
Documenting Results
To Next Page
Loading...
