Rohde & Schwarz R&S RTB2004 - Basic Function Generator Settings

Signal Generation (Option R&S RTB-B6)
R&S
®
RTB2000
229User Manual 1333.1611.02 ─ 04
14.1.1 Basic Function Generator Settings
Output
Enables the function generator.
Remote command:
WGENerator:OUTPut[:ENABle] on page 446
Function
Selects the type of waveform to be generated.
"DC"
Generates a direct current (DC) signal.
"Sine"
Generates a sine wave. You can set the Frequency.
"SinC"
Generates a cardinal sine wave. You can set the Frequency.
"Rectangle"
Generates a square wave. You can set the Frequency.
"Pulse"
Generates a pulse signal. You can set the Frequency, the Duty Cycle
and the Edge Time.
"Traingle"
Generates a triangle signal. You can set the Frequency.
"Ramp"
Generates a ramp signal. You can set the Frequency and Polarity.
Function Generator