Signal Generation (Option R&S RTB-B6)
R&S
®
RTB2000
230User Manual 1333.1611.02 ─ 04
"Exponential"
Generates an exponential rise signal. You can set the Frequency and
Polarity.
Remote command:
WGENerator:FUNCtion on page 442
Frequency
Sets the frequency of the waveform. The available frequency range depends on the
selected function. For more details refer to the datasheet.
Remote command:
WGENerator:FREQuency on page 442
Polarity
Sets the polarity.
For the "Exponential" function, you can choose between a rising or falling exponential.
For the "Ramp" function, you can set a positive or negative polarity.
Remote command:
WGENerator:FUNCtion:EXPonential:POLarity on page 443
WGENerator:FUNCtion:RAMP:POLarity on page 443
Edge Time
Sets the pulse edge time.
Remote command:
WGENerator:FUNCtion:PULSe:ETIMe on page 443
Duty Cycle
Sets the duty cycle for the pulse function. The duty cycle expresses for what percent-
age of the period, the signal state is high.
Remote command:
WGENerator:FUNCtion:PULSe:DCYCle on page 442
Amplitude
Sets the amplitude of the waveform.
Remote command:
WGENerator:VOLTage on page 442
Offset
Sets the vertical offset of the generated waveform.
Remote command:
WGENerator:VOLTage:OFFSet on page 442
Noise
Sets the noise of the generated waveform.
Remote command:
WGENerator:NOISe:ABSolute on page 446
WGENerator:NOISe:RELative on page 446
Function Generator
To Next Page
Loading...
