Rohde & Schwarz R&S RTB2004 - USB Settings

Remote Control Commands
R&S
®
RTB2000
368User Manual 1333.1611.02 ─ 04
<ThirdByte> Range: 0 to 255
Increment: 1
<FourthByte> Range: 0 to 255
Increment: 1
SYSTem:COMMunicate:INTerface:ETHernet:IPPort <IPPort>
Returns or specifies the IP port number (default = 5025).
Parameters:
<IPPort> Range: 1024 to 65535
SYSTem:COMMunicate:INTerface:ETHernet:HTTPport <HTTPport>
Returns or specifies the VXI-11 port number (default = 1024).
Parameters:
<HTTPport> Range: 0 to 65535
SYSTem:COMMunicate:INTerface:ETHernet:TRANsfer <TransferMode>
Enables automatic transfer speed selection, or selects one of the predefined settings
that corresponds to your network data rate.
Parameters:
<TransferMode> AUTO | FD10 | FD100 | HD10 | HD100
AUTO
Automatic transfer speed
FD10 | FD100 | HD10 | HD100
FD = full duplex, HD = half duplex
10 = 10 Mbps, 100 = 100 Mbps
SYSTem:COMMunicate:INTerface:ETHernet:MACaddress?
Returns the instrument's media access control address.
Return values:
<MACaddress> String data
String parameter
Usage: Query only
15.10.4 USB Settings
The following command takes effect if SYSTem:COMMunicate:INTerface[:
SELect] is set to USB.
General Instrument Setup