Rohde & Schwarz R&S RTB2004 - Page 373

Remote Control Commands
R&S
®
RTB2000
365User Manual 1333.1611.02 ─ 04
SYSTem:COMMunicate:INTerface[:SELect]
Selects the interface for remote control and web browser access ( ETHernet only).
Parameters:
<Interface> USB | ETHernet
SYSTem:BEEPer:CONTrol:STATe
Enables or disables a sound for general control events, e.g. changing the measure-
ment type in the "Measure" menu.
Parameters:
<ControlBeep> ON | OFF
SYSTem:BEEPer:ERRor:STATe
Enables or disables the beep if an error occurs.
Parameters:
<ErrorBeep> ON | OFF
SYSTem:BEEPer:TRIG:STATe
Enables or disables the beep if a trigger occurs.
Parameters:
<TriggerBeep> ON | OFF
SYSTem:BEEPer[:IMMediate]
Generates an immediate beep. You can use this command, for example, to locate the
instrument.
Usage:
Event
SYSTem:SET <Setup>
Defines or queries the device settings that can be saved and load manually with FILE >
"Device Settings".
Parameters:
<Setup> 488.2 block data
Usage: SCPI confirmed
SYSTem:ERRor[:NEXT]?
Returns the oldest item of the error/event queue and removes it from the queue.
General Instrument Setup