Rohde & Schwarz R&S RTB2004 - LAN Settings

Remote Control Commands
R&S
®
RTB2000
367User Manual 1333.1611.02 ─ 04
Return values:
<SystemTree> List of commands
Usage: Query only
15.10.3 LAN Settings
The following commands take effect if SYSTem:COMMunicate:INTerface[:
SELect] is set to ETHernet.
SYSTem:COMMunicate:INTerface:ETHernet:DHCP..........................................................367
SYSTem:COMMunicate:INTerface:ETHernet:IPADdress................................................... 367
SYSTem:COMMunicate:INTerface:ETHernet:SUBNet....................................................... 367
SYSTem:COMMunicate:INTerface:ETHernet:GATeway.....................................................367
SYSTem:COMMunicate:INTerface:ETHernet:IPPort..........................................................368
SYSTem:COMMunicate:INTerface:ETHernet:HTTPport.....................................................368
SYSTem:COMMunicate:INTerface:ETHernet:TRANsfer.....................................................368
SYSTem:COMMunicate:INTerface:ETHernet:MACaddress?.............................................. 368
SYSTem:COMMunicate:INTerface:ETHernet:DHCP
Enables DHCP for automatic network parameter distribution.
Parameters:
<DHCP> ON | OFF
OFF
Use the following commands to specify connection parameters:
SYSTem:COMMunicate:INTerface:ETHernet:IPADdress
on page 367
SYSTem:COMMunicate:INTerface:ETHernet:SUBNet
on page 367
SYSTem:COMMunicate:INTerface:ETHernet:GATeway
on page 367
SYSTem:COMMunicate:INTerface:ETHernet:IPADdress
SYSTem:COMMunicate:INTerface:ETHernet:SUBNet
SYSTem:COMMunicate:INTerface:ETHernet:GATeway
Return or specify.
●
IP address of the instrument.
●
IP subnet mask used by the instrument.
●
IP gateway used by the instrument.
Parameters:
<FirstByte> Range: 0 to 255
Increment: 1
<SecondByte> Range: 0 to 255
Increment: 1
General Instrument Setup