Rohde & Schwarz R&S RTB2004 - Instrument Tour; Front Panel

Getting Started
R&S
®
RTB2000
21User Manual 1333.1611.02 ─ 04
To shut down the instrument to standby state
► Press the STANDBY key.
All current settings are saved, and the software shuts down. Now it is safe to power
off the instrument.
2.1.3.3 Powering Off
Powering off is required only if the instrument must be disconnected from all power
supplies.
1. If the instrument is running, press the STANDBY key on the front panel to shut
down the instrument.
2. Switch the main power switch at the rear of the instrument to position 0.
3. Disconnect the AC power cable from the AC power supply.
Risk of losing data
If you switch off the running instrument using the rear panel switch or by disconnecting
the power cord, the instrument loses its current settings. Furthermore, program data
can be lost.
Press the Standby key first to shut down the application properly.
2.2 Instrument Tour
2.2.1 Front Panel
Figure 2-1 shows the front panel of the R&S RTB2000. The function keys are grouped
in functional blocks to the right of the display.
Instrument Tour