Rohde & Schwarz R&S RTB2004 - Probe Settings

Waveform Setup
R&S
®
RTB2000
43User Manual 1333.1611.02 ─ 04
"Fire"
Display in fire colors. Yellow corresponds to rare occurrences of the
samples, while red indicates frequent ones.
"Default"
Displays the waveform in its default monochrome color.
4.2.4 Probe Settings
In the probe menu, you set the probe attenuation for the selected channel. You can
select a default factor, for example "10:1", or enter a user-defined value.
Access: CH <N> > "Probe" (scroll down). Or: short menu > "Probe"
User
If default values do not fit, you can enter an arbitrary attenuation factor in the range
between 0.001:1 and 1000:1. The vertical scaling and measured values are multiplied
by this factor so that the displayed values are equal to the undivided measured signal
values.
Remote command:
PROBe<m>:SETup:ATTenuation:MANual on page 258
Unit
Selects the unit that the probe can measure.
●
V - for voltage measurements
●
A - for current measurements
Remote command:
PROBe<m>:SETup:ATTenuation:UNIT on page 258
Probe Adjust
Starts the probe adjustment procedure. A wizard explains the adjustment step by step.
Vertical Setup