Rohde & Schwarz R&S RTB2004 - Search:source

Remote Control Commands
R&S
®
RTB2000
284User Manual 1333.1611.02 ─ 04
SEARch:SOURce <SearchSource>
Selects the waveform to be analyzed.
Parameters:
<SearchSource> CH1 | CH2 | CH3 | CH4 | QMA | RE1 | RE2 | RE3 | RE4
Any active channel, math, or reference waveform can be
searched.
For protocol search on CAN and LIN signals, an active serial
bus is the search source.
*RST: CH1
Example: Chapter 15.2.3.1, "Searching for a Pulse of Specified Width",
on page 246
15.6.4.2 Edge Search Configuration
SEARch:TRIGger:EDGE:SLOPe..................................................................................... 284
SEARch:TRIGger:EDGE:LEVel....................................................................................... 284
SEARch:TRIGger:EDGE:LEVel:DELTa............................................................................ 284
SEARch:TRIGger:EDGE:SLOPe <Slope>
Sets the slope to be searched for.
Parameters:
<Slope> POSitive | NEGative | EITHer
*RST: POS
SEARch:TRIGger:EDGE:LEVel <Level>
Sets the voltage level for the edge search.
Parameters:
<Level> *RST: 0.5 V
SEARch:TRIGger:EDGE:LEVel:DELTa <DeltaLevel>
Sets a hysteresis range above and below the search level to avoid unwanted search
results caused by noise oscillation around the level.
Parameters:
<DeltaLevel> Range: Lower limit depends on vertical scale and other set-
tings, no upper limit
*RST: 0.2 V
Waveform Analysis