Rohde & Schwarz R&S RTB2004 - Page 287

Remote Control Commands
R&S
®
RTB2000
279User Manual 1333.1611.02 ─ 04
REFCurve<m>:HORizontal:SCALe..................................................................................281
REFCurve<m>:VERTical:POSition...................................................................................281
REFCurve<m>:VERTical:SCALe..................................................................................... 281
REFCurve<m>:SOURce <Source>
Defines the source of the reference waveform.
Suffix:
<m>
.
1..4
Selects the reference waveform
Parameters:
<Source> CH1 | CH2 | CH3 | CH4 | QMA | RE1 | RE2 | RE3 | RE4 | D70 |
D158 | SPEC | MINH | MAXH | AVER
CH1 | CH2 | CH3 | CH4 | QMA | RE1 | RE2 | RE3 | RE4
Any active channel, math, or reference waveform. CH3 and CH4
are only available with 4-channel R&S RTB2000 oscilloscopes.
D70 | D158
Logic probes, sources require MSO option R&S RTB-B1.
SPEC | MINH | MAXH | AVER
FFT waveforms: spectrum, min hold, max hold, average.
*RST: CH1
REFCurve<m>:SOURce:CATalog?
Returns the source waveform.
Suffix:
<m>
.
1..4
Selects the reference waveform.
Parameters:
<Source Catalogue> CH1 | CH2 | CH3 | CH4 | QMA | RE1 | RE2 | RE3 | RE4 | D70 |
D158 | SPEC | MINH | MAXH | AVER
See REFCurve<m>:SOURce on page 279.
Usage: Query only
REFCurve<m>:STATe
Displays or hides the selected reference waveform.
Suffix:
<m>
.
1..4
Selects the reference waveform.
Parameters:
<State> ON | OFF
*RST: OFF
Waveform Analysis