Rohde & Schwarz R&S RTB2004 - Page 288

Remote Control Commands
R&S
®
RTB2000
280User Manual 1333.1611.02 ─ 04
REFCurve<m>:UPDate
Updates the selected reference by the waveform defined with REFCurve<m>:SOURce.
Suffix:
<m>
.
1..4
Selects the reference waveform.
Usage: Event
REFCurve<m>:SAVE <Filename>
Stores the reference waveform in the specified file.
Suffix:
<m>
.
1..4
Selects the reference waveform.
Setting parameters:
<Filename> String with path and file name
Usage: Setting only
REFCurve<m>:LOAD <Filename>
Loads the waveform data from the indicated reference file to the reference waveform.
To load the correspondent instrument settings, use REFCurve<m>:LOAD:STATe
on page 280.
Suffix:
<m>
.
1..4
Selects the reference waveform.
Setting parameters:
<Filename> String with path and file name
Usage: Setting only
REFCurve<m>:LOAD:STATe
Loads the instrument settings in addition to the reference waveform data. The wave-
form data must be loaded before the settings, see REFCurve<m>:LOAD on page 280.
The settings are only available if the file was stored to the internal storage and never
written to a USB flash device.
Suffix:
<m>
.
1..4
Selects the reference waveform.
Usage: Event
Waveform Analysis