Rohde & Schwarz R&S RTB2004 - Page 338

Remote Control Commands
R&S
®
RTB2000
330User Manual 1333.1611.02 ─ 04
Usage: Query only
SPECtrum:FREQuency:AVERage:COUNt <AverageCount>
Defines the number of spectrums used for averaging.
Parameters:
<AverageCount>
SPECtrum:FREQuency:POSition
Defines the position of the spectrum.
Parameters:
<Position>
SPECtrum:FREQuency:RESet
Resets the Min Hold, Max Hold, Spectrum and Average waveforms to the current
waveform.
Usage:
Event
SPECtrum:FREQuency:SCALe
Sets the scaling of the spectrum analysis waveform.
Parameters:
<Scale>
15.8.2.2 Frequency Settings
SPECtrum:FREQuency:CENTer......................................................................................330
SPECtrum:FREQuency:FULLspan...................................................................................331
SPECtrum:FREQuency:SPAN.........................................................................................331
SPECtrum:FREQuency:STARt........................................................................................331
SPECtrum:FREQuency:STOP.........................................................................................331
SPECtrum:FREQuency:BANDwidth[:RESolution][:VALue]..................................................331
SPECtrum:FREQuency:CENTer
Defines the position of the displayed frequency domain, which is (Center - Span/2) to
(Center + Span/2). The width of the domain is defined using the command SPECtrum:
FREQuency:SPAN.
Parameters:
<CenterFrequency>
Applications