Remote Control Commands
R&S
®
RTB2000
331User Manual 1333.1611.02 ─ 04
SPECtrum:FREQuency:FULLspan
Performs the spectrum analysis calculation for the full frequency span.
Usage: Event
SPECtrum:FREQuency:SPAN
The span is specified in Hertz and defines the width of the displayed frequency range,
which is (Center - Span/2) to (Center + Span/2).
Parameters:
<Span>
SPECtrum:FREQuency:STARt
Defines the start frequency of the displayed frequency domain at the left display edge:
Center - Span/2
You can set start and stop frequency instead of defining a center frequency and span.
Parameters:
<StartFrequency> Range: Depends on various other settings, mainly on time
base, span/RBW ratio, and center frequency.
SPECtrum:FREQuency:STOP
Defines the stop frequency of the displayed frequency domain at the right display
edge: Center + Span/2
You can set start and stop frequency instead of defining a center frequency and span.
Parameters:
<StopFrequency> Range: Depends on various other settings, mainly on time
base, span/RBW ratio, and center frequency.
SPECtrum:FREQuency:BANDwidth[:RESolution][:VALue] <ResolutionBandwidth>
Defines the resolution bandwidth - the minimum frequency step at which the individual
components of a spectrum can be distinguished.
Parameters:
<ResolutionBandwidth>Range: Depends on various other settings.
15.8.2.3 Waveform Settings
SPECtrum:WAVeform:AVERage[:ENABle]....................................................................... 332
SPECtrum:WAVeform:MAXimum[:ENABle].......................................................................332
SPECtrum:WAVeform:MINimum[:ENABle]........................................................................332
SPECtrum:WAVeform:SPECtrum[:ENABle]...................................................................... 332
SPECtrum:WAVeform:AVERage:DATA?..........................................................................332
Applications
To Next Page
Loading...
