Remote Control Commands
R&S
®
RTB2000
311User Manual 1333.1611.02 ─ 04
MEASurement<m>:STATistics:RESet
Deletes the statistical results for all measurements, and starts a new statistical evalua-
tion if the acquisition is running. The waveform count is set to 0 and all measurement
values are set to NAN.
Suffix:
<m>
.
1..4
The suffix is irrelevant.
Usage: Event
15.7.2.2 Measurements Results
You can query the statistical results using the MEAS:STAT commands.
To export statistical results to a csv file, use the EXP:MEAS:STAT commands. Note
that export of statistics is possible only remotely, but not in manual operation.
MEASurement<m>:RESult[:ACTual]?.............................................................................. 311
MEASurement<m>:RESult:AVG?.................................................................................... 312
MEASurement<m>:RESult:STDDev?...............................................................................312
MEASurement<m>:RESult:NPEak?.................................................................................312
MEASurement<m>:RESult:PPEak?................................................................................. 312
MEASurement<m>:RESult:WFMCount?...........................................................................313
MEASurement<m>:STATistics:WEIGht............................................................................ 313
MEASurement<m>:STATistics:VALue:ALL?..................................................................... 313
MEASurement<m>:STATistics:VALue<n>?...................................................................... 314
EXPort:MEASurement<m>:STATistics:NAME...................................................................314
EXPort:MEASurement<m>:STATistics:SAVE....................................................................314
EXPort:MEASurement:STATistics:ALL:NAME...................................................................314
EXPort:MEASurement:STATistics:ALL:SAVE................................................................... 315
MEASurement<m>:RESult[:ACTual]? [<MeasType>]
Returns the result of the specified measurement type.
Suffix:
<m>
.
1..4
Selects the measurement place.
Query parameters:
<MeasType> FREQuency | PERiod | PEAK | UPEakvalue | LPEakvalue |
PPCount | NPCount | RECount | FECount | HIGH | LOW |
AMPLitude | MEAN | RMS | RTIMe | FTIMe | PDCYcle |
NDCYcle | PPWidth | NPWidth | CYCMean | CYCRms |
STDDev | CYCStddev | DELay | PHASe | BWIDth |
POVershoot | NOVershoot
Specifies the measurement type, see MEASurement<m>:MAIN
on page 307. If you omit the parameter, the result of the last
measurement setup is returned.
Measurements
To Next Page
Loading...
