Rohde & Schwarz R&S RTB2004 - Page 133

Applications
R&S
®
RTB2000
125User Manual 1333.1611.02 ─ 04
Remote command: DISPlay:MODE on page 334
To analyze the signal in the XY-diagram, you can use cursor measurements. You can
select specific cursor measurement types:"Voltage X", "Voltage Y1", "Voltage Y2" use
2 cursor lines, "Voltage X-Y1" and "Voltage X-Y2" use 4 cursor lines.
Source X
Defines the source to be displayed in x-direction in an XY-diagram, replacing the usual
timebase. The source can be any of the analog channels.
Remote command:
DISPlay:XY:XSOurce on page 335
Source Y1
Defines the first signal to be displayed in y-direction in an XY-diagram. The source can
be any of the active analog channels.
Remote command:
DISPlay:XY:Y1Source on page 335
Source Y2
Defines an optional second source to be displayed in y-direction in an XY-diagram.
The source can be any of the analog channels. The setting is only relevant for 4-chan-
nel R&S RTB2000 instruments.
XY-Diagram