General Instrument Setup
R&S
®
RTB2000
153User Manual 1333.1611.02 ─ 04
2. Connect the USB flash drive to the USB connector at the front of the instrument.
3. Tap the "Menu" icon in the lower right corner of the screen.
4. Scroll down the menu. Tap "Setup".
5. Select "Firmware Update"
Now you can see an info window with information about the installed and new firm-
ware and front controller firmware. If you have no newer firmware than the installed
one, a message appears.
6. Tap "Execute" to start the firmware update.
Wait until the update has finished. After installation, the instrument restarts auto-
matically.
Updating the Firmware
To Next Page
Loading...
