Rohde & Schwarz R&S RTB2004 - Page 174

Serial Bus Analysis
R&S
®
RTB2000
166User Manual 1333.1611.02 ─ 04
●
SPI (2 wires)
●
SSPI (3 wires)
●
I
2
C
●
UART
●
CAN
●
LIN
Remote command:
BUS<b>:TYPE on page 370
Decode
Enables protocol decoding for the selected bus.
Remote command:
BUS<b>:STATe on page 370
Configuration
Opens or closes the dialog box with configuration settings of the selected bus.
The following chapters describe manual protocol configuration:
●
Chapter 13.5, "Parallel Buses", on page 224
●
Chapter 12.2.2, "SPI/SSPI Configuration", on page 173
●
Chapter 12.3.2, "I
2
C Configuration", on page 182
●
Chapter 12.4.2, "UART Configuration", on page 189
●
Chapter 12.5.1, "CAN Configuration", on page 195
●
Chapter 12.6.2, "LIN Configuration", on page 209
Trigger
Opens the trigger setup for the selected protocol.
The following chapters describe protocol triggering:
●
Chapter 12.2.3, "SPI/SSPI Trigger", on page 176
●
Chapter 12.3.3, "I
2
C Trigger", on page 183
●
Chapter 12.4.3, "UART Trigger", on page 191
●
Chapter 12.5.2, "CAN Trigger", on page 197
●
Chapter 12.6.3, "LIN Trigger", on page 210
Triggering on parallel buses is not possible.
Note: Selecting "Trigger" in the protocol menu automatically enables protocol decod-
ing.
Display Setup
Opens a menu to define display settings, e.g. data formats. Display settings are valid
for all protocol types.
See Chapter 12.1.2, "Display Settings", on page 167.
Label List
Opens a menu to load and apply a list with symbolic names of addresses or identifiers.
Only available for CAN and LIN.
See Chapter 12.1.5, "Label List", on page 169.
Basics of Protocol Analysis