Remote Control Commands
R&S
®
RTB2000
300User Manual 1333.1611.02 ─ 04
LOGic<p>:HISTory:PLAYer:SPEed <PlayerSpeed>
SPECtrum:HISTory:PLAYer:SPEed <PlayerSpeed>
CHANnel<m>:HISTory:PLAYer:SPEed <PlayerSpeed>
Sets the speed of the history replay.
Parameters:
<PlayerSpeed> SLOW | MEDium | FAST | AUTO
*RST: AUTO
BUS<b>:HISTory:REPLay
<Replay>
DIGital<m>:HISTory:REPLay <Replay>
LOGic<p>:HISTory:REPLay <Replay>
SPECtrum:HISTory:REPLay <Replay>
CHANnel<m>:HISTory:REPLay <Replay>
If set to ON, the replay of the selected history segments repeats automatically.
Parameters:
<Replay> ON | OFF
*RST: STOP
BUS<b>:HISTory:PLAYer:STATe <PlayerState>
DIGital<m>:HISTory:PLAYer:STATe <PlayerState>
LOGic<p>:HISTory:PLAYer:STATe <PlayerState>
SPECtrum:HISTory:PLAYer:STATe <PlayerState>
CHANnel<m>:HISTory:PLAYer:STATe <PlayerState>
Starts and stops the replay of the history segments.
Parameters:
<PlayerState> RUN | STOP
*RST: STOP
15.6.5.3 Timestamps
You can query the timestamps of history segments in two ways:
●
Query for the timestamps of all history segments using ...:HISTory:...:ALL
commands.
●
Query for the timestamp of a specific segment using ...:HISTory:... com-
mands. Select the segment of interest using CHANnel<m>:HISTory:CURRent
appropriate command.
The commands in this chapter use numeric suffixes:
●
CHANnel<m>: Selects the analog input channel.
●
DIGital<m>: Selects the logic channel, range 0..15
●
LOGic<p>: Selects the logic pod, range 1..2
●
BUS<b>: Selects the bus, range 1..4
Waveform Analysis
To Next Page
Loading...
