Rohde & Schwarz RTM2032 - Editing Equations and Equation Sets

Mathematics
R&S
®
RTM20xx
99User Manual 1317.4726.02 ─ 01
If the required equation is not included, edit the current equation set, or load an appro-
priate equation set that was saved before. See also: "To configure an equation"
on page 99 and "To load an equation set" on page 101.
7.1.2 Editing Equations and Equation Sets
To each math waveform an equation is assigned. The mathematical operation is defined
by the operator and is performed on the operands. Operands are one or two of the active
channel or math waveforms, or a constant value.
All five math waveforms together build an equation set that can be stored and loaded.
To configure an equation
1. Press "MATH > Edit Equations" to display the "Equation Set Editor" with the current
equation set configuration.
2. Press "Equation" and select the equation to be configured.
3. Press "Operator" to select the operator of the equation.
See also: "Operator" on page 103.
4. Press "Operand1".
See also: "Operand 1" on page 107.
5. If the equation requires a second operand, press "Operand2" and define the second
operand.
6. If one of the operands is defined as a constant, define its value:
a) Press "Operand1" or "Operand2" to select the constant for the corresponding
operand.
b) Press "Edit Constant" to define its value.
c) Press "Constant" and select either a pre-defined constant, or one of 10 available
user-defined constants.
Configuring and Using Math Waveforms