Rohde & Schwarz RTM2032 - Reference for Markers

Display
R&S
®
RTM20xx
73User Manual 1317.4726.02 ─ 01
2. If not yet active, activate the zoom function by pressing the ZOOM key.
The marker lines are displayed both in the original window and in the zoom window.
3. Select the marker that indicates the area you want to zoom into using the NEXT or
PREV key.
The center of the zoom area is moved to the marker (see figure 4-3).
4. If necessary, fine-tune the position of the zoom area around the marker as described
in "To configure the zoom area via the rotary knobs" on page 69.
4.4.2 Reference for Markers
The marker keys are used for both marker types, timestamp markers and search result
markers.
For details on setting and moving markers; see
● chapter 4.4.1, "Using Timestamp Markers", on page 71
● "To use markers on search results" on page 135
NEXT.............................................................................................................................73
PREV............................................................................................................................73
SET CLEAR..................................................................................................................73
NEXT
Moves the next (right) marker to the reference point of the display or zoom area. If a
search is enabled, the key navigates the search result markers.
Note: If another marker is available at the right, but currently not visible on the screen, a
small red arrow is displayed at the right edge of the display.
Remote command:
TSTamp:NEXT on page 321 (for timestamp markers only)
PREV
Moves the previous (left) marker to the reference point of the display or zoom area. If a
search is enabled, the key navigates the search result markers.
Note: If another marker is available at the left, but currently not visible on the screen, a
small red arrow is displayed at the left edge of the display.
Remote command:
TSTamp:PREVious on page 321 (for timestamp markers only)
SET CLEAR
Sets a new marker at the reference point of the display, or deletes an existing marker at
this point. Use the NEXT and PREV keys to move the markers to the reference point.
In the display of search results, the marker is set to or removed from the search result
that is selected in the "Event Table".
Markers