Reference Waveforms
R&S
®
RTM20xx
75User Manual 1317.4726.02 ─ 01
2. Press "Reference" and select the reference storage position.
If a reference was already loaded to the selected reference position before, the stored
reference waveform is displayed.
3. Select the data that will be used as reference by doing one of the following:
● Press "Source" and select one of the active waveforms, then press "Update".
● Load a previously saved reference.
See also: "To load references and reference settings" on page 75.
The selected data is written to the selected reference storage and displayed.
4. Press "Visible" to hide and show the reference waveform.
5.1.2 Saving and Loading References
If you need more than four references, or you want to keep a reference for other meas-
urements, you can save it and load it back to the instrument when needed. Import and
export is also possible.
The instrument settings are saved together with the reference waveform only in the inter-
nal storage. They are removed from the reference file when you save or export the file
to an external storage (USB flash device).
To save references
1. Press REF to display the "Reference" menu
2. Press "Save".
3. Press "Source" and select the waveform whose data you want to save as a reference.
All active waveforms can be saved.
4. Press "Storage" and define the storage settings.
See: "To select the storage directory" on page 218.
5. Press "File Name" and enter the name of the target file.
See: "To define a new file or directory name" on page 218.
6. Press "Save".
To copy a stored reference, use FILE > "Import/Export References". For import/export
procedure, see chapter 13.2.1.2, "Importing and Exporting Data", on page 218.
To load references and reference settings
1. Press REF.
2. Press "Load".
3. Press "Reference" and select the reference number you want to load the reference
to.
Using References
To Next Page
Loading...
