Rohde & Schwarz RTM2032 - Search on Decoded LIN Data

Protocol Analysis
R&S
®
RTM20xx
205User Manual 1317.4726.02 ─ 01
● BUS<b>:LIN:FRAMe<n>:DATA? on page 426
● BUS<b>:LIN:FRAMe<n>:STATus? on page 427
● BUS<b>:LIN:FRAMe<n>:STARt? on page 427
● BUS<b>:LIN:FRAMe<n>:STOP? on page 427
● BUS<b>:LIN:FRAMe<n>:VERSion? on page 430
● BUS<b>:LIN:FRAMe<n>:CSSTate? on page 428
● BUS<b>:LIN:FRAMe<n>:CSValue? on page 428
● BUS<b>:LIN:FRAMe<n>:IDPValue? on page 428
● BUS<b>:LIN:FRAMe<n>:IDSTate? on page 429
● BUS<b>:LIN:FRAMe<n>:IDValue? on page 429
● BUS<b>:LIN:FRAMe<n>:SYSTate? on page 429
● BUS<b>:LIN:FRAMe<n>:SYValue? on page 430
● BUS<b>:LIN:FRAMe<n>:BCOunt? on page 430
● BUS<b>:LIN:FRAMe<n>:BYTE<o>:STATe? on page 431
● BUS<b>:LIN:FRAMe<n>:BYTE<o>:VALue? on page 431
11.6.6 Search on Decoded LIN Data
Using the search functionality, you can find various events in the decoded data, the same
events which you also can trigger on. Before you can start the search, you have to con-
figure the bus correctly and acquire decoded data.
To search on decoded data, use the search type "Protocol". The source is automatically
set to the configured protocol.
See also: chapter 10, "Search", on page 132.
11.6.6.1 LIN Search Setup
Event
Sets the event or combination of events to be searched for. Depending on the selected
event, the appropriate settings in the softkey menu are activated.
Remote command:
SEARch:PROTocol:LIN:CONDition on page 432
Frame Setup
Selects the frame type to be searched for: Start of frame or wakeup frame.
LIN (Option R&S RTM-K3)