Measurements
R&S
®
RTM20xx
85User Manual 1317.4726.02 ─ 01
Next peak
For FFT analysis only: sets the selected cursor to the next (right) level peak.
To select the cursor, press the NAVIGATION knob.
Remote command:
CURSor<m>:SNPeak on page 331
NAVIGATION
Select cursor: Press the NAVIGATION rotary knob to select a cursor line. If a menu is
open, it is closed. Press the knob repeatedly to select the required cursor line or - if
Coupling is enabled - a pair of coupled cursor lines.
Move selected cursor: Turn the rotary knob to change the position of the selected cursor
line.
Remote command:
CURSor<m>:X1Position on page 330
CURSor<m>:X2Position on page 330
CURSor<m>:X3Position on page 330
CURSor<m>:Y1Position on page 330
CURSor<m>:Y2Position on page 330
CURSor<m>:Y3Position on page 330
6.2 Quick Measurements
Quick measurement performs all currently available automatic measurements for the
selected channel. The measurements cannot be configured. The results are displayed
either directly at the waveform (WF) or in the right part of the result table (T) and are
updated continuously.
► Press the QUICK MEAS key to activate quick measurement.
Quick Measurements
To Next Page
Loading...
