Rohde & Schwarz RTM2032 - Search

Remote Control
R&S
®
RTM20xx
358User Manual 1317.4726.02 ─ 01
Parameters:
<EventMode> OFF | EACH | SINGle | CYCLic
OFF
No action is executed.
EACH
The selected action is executed on each violation of the mask.
SINGle
The selected action is executed once after the n-th violation.
CYCLic
The selected action is executed repeatedly after each n-th viola-
tion.
The number of violations <n> is set with the relevant 
MASK:ACTion:...:EVENt:COUNt command.
*RST:
OFF
Firmware/Software: FW 03.800
MASK:ACTion:SOUNd:EVENt:COUNt <EventCount>
MASK:ACTion:STOP:EVENt:COUNt <EventCount>
MASK:ACTion:SCRSave:EVENt:COUNt <EventCount>
MASK:ACTion:PRINt:EVENt:COUNt <EventCount>
MASK:ACTion:WFMSave:EVENt:COUNt <EventCount>
Sets the number of mask violations after which the action is executed. The command is
only relevant if the associated MASK:ACTion:...:EVENt:MODE is set to SINGle or
CYCLic.
Parameters:
<EventCount> Integer value, number of mask violations
Firmware/Software: FW 03.800
15.2.12 Search
● General Search Configuration...............................................................................359
● Edge Search Configuration...................................................................................362
● Width Search Configuration..................................................................................362
● Peak Search Configuration...................................................................................364
● Rise/Fall Time Search Configuration....................................................................365
● Runt Search Configuration....................................................................................366
● Data2Clock Search Configuration.........................................................................368
● Pattern Search Configuration................................................................................370
● Search Results......................................................................................................372
Command Reference