Rohde & Schwarz RTM2032 - Protocol Analysis

Remote Control
R&S
®
RTM20xx
374User Manual 1317.4726.02 ─ 01
SEARch:RCOunt?
Returns the number of search results.
Return values:
<ResultCount> *RST: 0
Example:
chapter 15.3.2.1, "Searching for a Pulse of Specified Width",
on page 460
Usage: Query only
Firmware/Software: FW 03.400
15.2.13 Protocol Analysis
● General.................................................................................................................374
● SPI........................................................................................................................377
● SSPI......................................................................................................................386
● I²C.........................................................................................................................388
● UART....................................................................................................................399
● CAN.......................................................................................................................405
● LIN.........................................................................................................................421
15.2.13.1 General
Note: SPI/SSPI and UART protocols occupy two bus lines (bus 1 and 2 or bus 3 and 4).
If one of these buses is configured, the number of buses (suffix <b>) is reduced. Bus 2
and/or bus 4 is not available.
BUS<b>:STATe.............................................................................................................374
BUS<b>:TYPE...............................................................................................................375
BUS<b>:FORMat...........................................................................................................375
BUS<b>:DSIGnals.........................................................................................................375
BUS<b>:DSIZe..............................................................................................................375
BUS<b>:POSition..........................................................................................................376
BUS<b>:RESult.............................................................................................................376
BUS<b>:LIST?..............................................................................................................376
BUS<b>:LIST:SAVE.......................................................................................................376
BUS<b>:STATe <State>
Switches the protocol display on or off.
Suffix:
<b>
.
1..4
Selects the bus.
Note: SPI/SSPI and UART protocols occupy two bus lines.
Parameters:
<State> ON | OFF
*RST: OFF
Command Reference