Remote Control
R&S
®
RTM20xx
388User Manual 1317.4726.02 ─ 01
Parameters:
<BitOrder> MSBFirst | LSBFirst
*RST: MSBFirst
BUS<b>:SSPI:SSIZe <SymbolSize>
Sets the word length, the number of bits in a message.
Suffix:
<b>
.
1..4
Selects the bus.
Note: SPI/SSPI and UART protocols occupy two bus lines.
Parameters:
<SymbolSize> Range: 4 to 32
Increment: 1
*RST: 8
Default unit: Bit
CHANnel<m>:THReshold:FINDlevel
Executes the analysis of all analog channels that are configured for the selected bus and
sets the threshold for digitization of analog signals for each channel.
Suffix:
<m>
.
Selects the input channel. The number of channels depends on
the instrument.
Usage: Event
15.2.13.4 I²C
The Inter-Integrated Circuit is a simple, lowbandwidth, low-speed protocol used for com-
munication between on-board devices, for example, in LCD and LED drivers, RAM,
EEPROM, and others.
Note: SPI/SSPI and UART protocols occupy two bus lines (bus 1 and 2 or bus 3 and 4).
If one of these buses is configured, the number of buses (suffix <b>) is reduced. Bus 2
and/or bus 4 is not available.
● I²C - Configuration.................................................................................................388
● I²C - Trigger...........................................................................................................389
● I²C - Decode Results.............................................................................................392
I²C - Configuration
BUS<b>:I2C:CLOCk:SOURce.........................................................................................389
BUS<b>:I2C:DATA:SOURce...........................................................................................389
CHANnel<m>:THReshold:FINDlevel................................................................................389
Command Reference
To Next Page
Loading...
