Search
R&S
®
RTM20xx
132User Manual 1317.4726.02 ─ 01
10 Search
10.1 Search Conditions and Results
The search functions of R&S RTM allow to find all edges, pulse widths, peaks, or other
events in an acquisition that match the search conditions. For each search type, specific
settings are available. Searches can be performed on any channel, math or reference
waveform.
Searches can be performed online, that is repeatedly for each new data acquisition in a
running acquisition series, or only once after the acquisition has been stopped. In an
online search, only the displayed data is searched while the search on a stopped acqui-
sition analyzes the contents of the memory.
The searched time base range can be restricted by defining a gate.
10.1.1 Search Results
Search results are marked in the diagram and listed in a results table with their specific
measurement values. In the table, five results are shown. To navigate the search results,
turn the NAVIGATION knob. See also: "To analyze search results" on page 134.
Search result markers
For further analysis, for example, for cursor measurements, you can set up to 20 markers
to selected search results. Search result markers are different from usual timestamp
markers but they are set, navigated and deleted by means of the marker keys, too. As
long as a search is enabled, the search result markers are active. If search is off, usual
markers can be used.
See also:
● "To use markers on search results" on page 135
● chapter 4.4, "Markers", on page 71
Search Conditions and Results
To Next Page
Loading...
