Rohde & Schwarz RTM2032 - Acquisition and Setup

Remote Control
R&S
®
RTM20xx
281User Manual 1317.4726.02 ─ 01
Example:
See chapter 15.3.1.2, "Reading Waveform Data in Unsigned Inte-
ger Format", on page 458
Usage: Query only
CHANnel<m>:DATA:YRESolution?
CHANnel<m>:DATA:ENVelope:YRESolution?
CALCulate:MATH<m>:DATA:YRESolution?
REFCurve<m>:DATA:YRESolution?
Return the vertical bit resolution of the indicated waveform.
The commands are relevant for data conversion if binary data format is defined
(FORM UINT, 8|16|32).
Return values:
<Yresolution> For default waveforms, the resolution is 8 bit.
If high resolution, average or filter are set for the waveform, the
resolution is 16 bit.
Example:
See chapter 15.3.1.2, "Reading Waveform Data in Unsigned Inte-
ger Format", on page 458
Usage: Query only
15.2.4 Acquisition and Setup
● Starting and Stopping Acquisition.........................................................................281
● Time Base.............................................................................................................282
● Acquisition.............................................................................................................284
● Vertical..................................................................................................................288
● Waveform Data.....................................................................................................293
● Probes...................................................................................................................296
15.2.4.1 Starting and Stopping Acquisition
RUN.............................................................................................................................281
RUNContinous...............................................................................................................282
SINGle..........................................................................................................................282
RUNSingle....................................................................................................................282
ACQuire:NSINgle:COUNt................................................................................................282
STOP...........................................................................................................................282
RUN
Starts the continuous acquisition.
Usage:
Event
Asynchronous command
Command Reference