Rohde & Schwarz RTM2032 - Page 297

Remote Control
R&S
®
RTM20xx
282User Manual 1317.4726.02 ─ 01
RUNContinous
Same as RUN.
Usage: Event
Asynchronous command
SINGle
Starts a defined number of acquisitions. The number of acquisitions is set with 
ACQuire:NSINgle:COUNt.
Usage:
Event
Asynchronous command
RUNSingle
Same as SINGle.
Usage:
Event
Asynchronous command
ACQuire:NSINgle:COUNt <NSingleCount>
Sets the number of waveforms acquired with RUNSingle.
Parameters:
<NSingleCount> Number of waveforms
Range: 1 to 10
Increment: 1
*RST: 1
STOP
Stops the running acquistion.
Usage:
Event
Asynchronous command
15.2.4.2 Time Base
TIMebase:SCALe...........................................................................................................283
TIMebase:RATime?.......................................................................................................283
TIMebase:ACQTime.......................................................................................................283
TIMebase:RANGe..........................................................................................................283
TIMebase:DIVisions?.....................................................................................................283
TIMebase:POSition........................................................................................................284
TIMebase:REFerence.....................................................................................................284
Command Reference