Rohde & Schwarz RTM2032 - CAN Decode Results

Protocol Analysis
R&S
®
RTM20xx
192User Manual 1317.4726.02 ─ 01
29,0x03B1C002,Airbag_Status
29,0x01234ABC,NM_Gateway
# ----------------------------------------------------------------------------
Fig. 11-11: Label list for CAN
For general information, see chapter 11.1.4, "Label List", on page 151.
11.5.4 CAN Decode Results
You can enable the decoding in the "Protocol" main menu. "Decode" shows the decoded
values below the waveforms in the format selected with "Display". Additionally, you can
display the binary signal with "Bits".
See also: chapter 11.1.2, "Protocol - Common Settings", on page 149
Additionally, you can display and save a "Frame Table" containing decoded data: frame
number, start time of the frame, frame type, identifier, data length code, data, checksum,
and state of the frame.
See also: chapter 11.1.5, "Frame Table: Decode Results", on page 154
CAN (Option R&S RTM-K3)