Display
R&S
®
RTM20xx
71User Manual 1317.4726.02 ─ 01
Zoom Off
Closes the zoom window and returns to the previous display.
Remote command:
TIMebase:ZOOM:STATe on page 320
4.4 Markers
Markers allow you to mark certain positions on the screen, e.g. a rising or falling edge,
or an unexpected signal value, or a search result. You can then use the markers to identify
areas of interest you want to zoom into, and quickly move through the data.
Two marker types are available:
●
Timestamp markers can be used if no search is enabled. They can be set manually
at any position of the waveform. These markers are indicated by blue vertical lines.
You can set up to 8 timestamp markers. Timestamp markers are descibed in this
chapter.
●
If a search is active, you can set search markers to selected search results. These
markers are indicated by magenta search result flags. Search result markers are
described in chapter 10.1, "Search Conditions and Results", on page 132
4.4.1 Using Timestamp Markers
Timestamp markers are displayed as colored lines on the screen. If more markers are
available but currently not visible on the screen (e.g. in a zoomed display), this is indicated
by a small arrow at the right or left edge of the display.
See also: "To use markers on search results" on page 135.
Markers
To Next Page
Loading...
