Display
R&S
®
RTM20xx
70User Manual 1317.4726.02 ─ 01
Main Time Base............................................................................................................70
Zoom Time Base...........................................................................................................70
Trigger Offset................................................................................................................70
Zoom Time....................................................................................................................70
Zoom Off.......................................................................................................................71
Main Time Base
Defines the scaling for the time base in the (original) Y(t)-window in seconds per division.
The scaling is indicated by "TB" in the information bar above the window.
Note: If "Time Control" is selected, the main time base can be adjusted using the hori-
zontal SCALE rotary knob.
See also "SCALE" on page 23, "To configure the original Y(t)-diagram" on page 69 and
figure 8-2.
Remote command:
TIMebase:SCALe on page 283
Zoom Time Base
Defines the scaling for the time base in the zoom window in seconds per division. The
scaling determines the width of the zoom area that is displayed in the zoom window (10
divisions * scaling per division).
The zoom area is indicated by white lines in the original Y(t)-window.
Remote command:
TIMebase:ZOOM:SCALe on page 320
Trigger Offset
Defines the horizontal position of the trigger point in relation to the reference point - to
the zero point of the grid. The value is indicated by "T" in the information bar above the
window.
The reference point is set with SETUP >"Time Reference".
Note: If a zoom or FFT window is displayed and "Time Control" is selected, the trigger
offset can be adjusted using the horizontal POSITION rotary knob.
See also:
● "POSITION" on page 23
● "Time Reference" on page 235
● "To configure the original Y(t)-diagram" on page 69
Remote command:
TIMebase:POSition on page 284
Zoom Time
Defines the offset of the trigger point to the reference point 0s in the zoom window. The
offset determines the position of the zoom area that is displayed in the zoom window.
Remote command:
TIMebase:ZOOM:TIME on page 320
Zoom
To Next Page
Loading...
