Remote Control
R&S
®
RTM20xx
320User Manual 1317.4726.02 ─ 01
Parameters:
<Enable> ON | OFF
*RST: OFF
DISPlay:VSCReen:POSition <Position>
Selects the divisions to be displayed on the virtual screen. The virtual screen has 20
divisions, 8 of them are displayed.
Parameters:
<Position> Indicated the position of the middle visible division.
Range: -6 to 6. At -6, the lower 8 divisons are visible. 0 indi-
cates the center of the virtual screen, and the divions
-4 to 4 are visible.
15.2.6.2
Zoom
TIMebase:ZOOM:STATe................................................................................................320
TIMebase:ZOOM:SCALe................................................................................................320
TIMebase:ZOOM:TIME...................................................................................................320
TIMebase:ZOOM:POSition..............................................................................................321
TIMebase:ZOOM:STATe <ZoomState>
Switches the zoom window on or off.
Parameters:
<ZoomState> ON | OFF
*RST: OFF
TIMebase:ZOOM:SCALe <ZoomScale>
Defines the time base in the zoom diagram in seconds per division.
Parameters:
<ZoomScale> Range: Depends on various other settings
Default unit: s/div
TIMebase:ZOOM:TIME <Time>
Defines the offset of the trigger point to the reference point of the zoom diagram.
Parameters:
<Time> *RST: 0
Default unit: s
Command Reference
To Next Page
Loading...
