Measurements
R&S
®
RTM20xx
84User Manual 1317.4726.02 ─ 01
If MSO option R&S RTM-B1 is installed, also digital channels D0 to D15 are available for
time, ratio X, count, duty ratio, and burst width measurements, and the pods D0...D7 and
D8...D15 are available for V-marker measurements. Available sources depend on the
selected measurement type.
The source setting is not available for cursor measurements on FFT analysis and in XY
mode.
Remote command:
CURSor<m>:SOURce on page 327
Track Scaling
If enabled, "Track Scaling" adjusts the cursor lines if the vertical or horizontal scales are
changed. The cursor lines keep their relative position to the waveform.
If disabled, the cursor lines remain on their position on the display if the scaling is
changed.
Remote command:
CURSor<m>:TRACking:SCALe[:STATe] on page 331
Coupling
If enabled, the cursors of a can be coupled and moved together. Press the
NAVIGATION key to select both corsors or one cursor to be moved.
If disabled, the NAVIGATION key toggles the single cursor lines.
Remote command:
CURSor<m>:XCOupling on page 330
CURSor<m>:YCOupling on page 330
Set to Wave
Autoset for cursor lines, sets the cursor lines to typical points of the waveform depending
on the selected measurement type. For example, for voltage measurement, the cursor
lines are set to the upper and lower peaks of the waveform. For time measurement, the
cursor lines are set to the edges of two consecutive positive or two consecutive negative
pulses.
Remote command:
CURSor<m>:SWAVe on page 331
Set To Screen
Resets the cursors to their initial positions. This is helpful if the cursors have disappeared
from the display or need to be moved for a larger distance.
Remote command:
CURSor<m>:SSCReen on page 331
Prev. peak
For FFT analysis only: sets the selected cursor to the previous (left) level peak.
To select the cursor, press the NAVIGATION knob.
Remote command:
CURSor<m>:SPPeak on page 331
Cursor Measurements
To Next Page
Loading...
