Rohde & Schwarz RTM2032 - 6.3 Automatic Measurements; Automatic Measurements; Measurement Types and Results; Measurement Types

Measurements
R&S
®
RTM20xx
87User Manual 1317.4726.02 ─ 01
Remote command:
● MEASurement<m>:ALL[:STATe] on page 335
● MEASurement<m>:AON on page 335
● MEASurement<m>:AOFF on page 335
● MEASurement<m>:ARESult? on page 335
6.3 Automatic Measurements
Using the MEAS key you can configure up to four amplitude and time measurements or
pulse counts on one of the active channel, reference or math waveforms.
If MSO option R&S RTM-B1 is installed, active digital channels are available as mea-
surement sources for time and count measurements.
● Measurement Types and Results...........................................................................87
● Configuring and Performing Automatic Measurements..........................................93
● Auto Measure Menu (MEAS key)............................................................................94
6.3.1 Measurement Types and Results
● Measurement Types...............................................................................................87
● Measurement Results.............................................................................................92
● Statistics..................................................................................................................93
6.3.1.1 Measurement Types
The R&S RTM provides a varity of automatic measurements:
Mean Value...................................................................................................................88
RMS Value....................................................................................................................88
Mean Cycle...................................................................................................................88
RMS Cycle....................................................................................................................88
Peak Peak.....................................................................................................................88
Peak +...........................................................................................................................88
Peak -............................................................................................................................88
Frequency.....................................................................................................................88
Period............................................................................................................................89
Amplitude......................................................................................................................89
Crest factor....................................................................................................................89
Top Level......................................................................................................................89
Base Level....................................................................................................................89
Pulse Width (positive pulse)..........................................................................................89
Pos. Overshoot.............................................................................................................89
Neg. Overshoot.............................................................................................................89
Pulse Width (negative pulse)........................................................................................90
Duty Cycle +..................................................................................................................90
Automatic Measurements