Rohde & Schwarz RTM2032 - I 2 C Decode Results

Protocol Analysis
R&S
®
RTM20xx
173User Manual 1317.4726.02 ─ 01
7,0x51,EEPROM
10,0x3A2,DeviceSetup
10,0x1A3,GatewayStatus
10,0x06E,LeftSensor
# ----------------------------------------------------------------------------
Fig. 11-7: Label list for I²C
For general information, see chapter 11.1.4, "Label List", on page 151.
11.3.5
I
2
C Decode Results
You can enable the decoding in the "Protocol" main menu. "Decode" shows the decoded
values below the waveforms in the format selected with "Display". Additionally, you can
display the binary signal with "Bits".
See also: chapter 11.1.2, "Protocol - Common Settings", on page 149
Additionally, you can display and save a "Frame Table" containing decoded data: frame
number, start time of the frame, access type. ID, data and state of the frame.
See also: chapter 11.1.5, "Frame Table: Decode Results", on page 154
I²C (Option R&S RTM-K1)