Display
R&S
®
RTM20xx
59User Manual 1317.4726.02 ─ 01
Grid ← Intensities
Defines the intensity of the grid on the screen in percent. Enter a percentage between
0%and 100%. The default value is 34%.
Remote command:
DISPlay:INTensity:GRID on page 317
Persistence ← Intensities
Defines the persistence of the waveform on the screen.
"Off"
Deactivates persistence
"Automatic"
The optimal persistence time is determined automatically by the instru-
ment
"Manual"
User-defined persistence according to "Persist. Time" setting.
Remote command:
DISPlay:PERSistence:STATe on page 318
DISPlay:PERSistence:TIME:AUTO on page 318
Persist. Time ← Intensities
User-defined persistence time if "Manual" persistence is selected. Each new data point
remains on the screen for the duration defined here. Possible values are from 50 ms to
9.6 s or "Infinite". If "Infinite" is selected, each new data point remains on the screen
infinitely until this setting is changed or the persistence is cleared.
Remote command:
DISPlay:PERSistence:TIME on page 318
DISPlay:PERSistence:INFinite on page 318
Clear Persist. ← Intensities
Clears the displayed persistence on the screen.
Remote command:
DISPlay:PERSistence:CLEar on page 319
Dots Only
If activated, only the individual data points are displayed. If deactivated, the individual
data points are connected by a line. Define the strength of the line using the "INTEN-
SITY" knob on the left side of the screen.
Remote command:
DISPlay:STYLe on page 319
Inverse Brightn.
Inverts the brightness level of the signals. Normally, values that occur frequently are
brighter than rare values. This setting inverts this behavior: Rare values are brighter than
frequent values. Use this setting in combination with persistence to detect rare values
within the waveform.
Remote command:
DISPlay:PALette on page 314 (INVerse, IFColor)
General Display Settings
To Next Page
Loading...
