Rohde & Schwarz RTM2032 - Parallel Bus (Unclocked)

Mixed Signal Option (MSO, R&S RTM-B1)
R&S
®
RTM20xx
213User Manual 1317.4726.02 ─ 01
Slope
Selects if the data is sampled on the rising or falling slope of the clock, or on both edges
of a double data rate clock. The clock slope marks the begin of a new bit.
Remote command:
BUS<b>:CPARallel:CLOCK:SLOPe on page 438
12.3.2.2 Parallel Clocked Bus - Decode Results
You can enable the decoding in the "Protocol" main menu. "Decode" shows the decoded
values below the waveforms in the format selected with "Display". Additionally, you can
display the binary signal with "Bits".
See also: chapter 11.1.2, "Protocol - Common Settings", on page 149
Additionally, you can display and save a "Frame Table" containing decoded data: frame
number, start time of the frame, identifier, data length, data, checksum, and state of the
frame.
See also: chapter 11.1.5, "Frame Table: Decode Results", on page 154
Remote commands:
● BUS<b>:CPARallel:FCOunt? on page 439
● BUS<b>:CPARallel:FRAMe<n>:DATA? on page 439
● BUS<b>:CPARallel:FRAMe<n>:STATe? on page 440
● BUS<b>:CPARallel:FRAMe<n>:STARt? on page 440
● BUS<b>:CPARallel:FRAMe<n>:STOP? on page 440
12.3.3 Parallel Bus (Unclocked)
12.3.3.1 Parallel Bus - Configuration
The unclocked parallel bus can analyze up to 16 digital channels. The configuration is
simple, the only setting is the "Bus width".
Bus width
Sets the number of lines to be analyzed. The maximum number is 16 bits if all 16 digital
channels are used.
Remote command:
BUS<b>:PARallel:WIDTh on page 437
Parallel Buses