Rohde & Schwarz RTM2032

To Next Page

To Previous Page

Remote Control

R&S

RTM20xx

438User Manual 1317.4726.02 ─ 01

Parameters:

<BusWidth> Maximum number is the number of input channels.

Range: 1 to 16

Increment: 1

*RST: 4

Default unit: Bit

Parallel Clocked Bus - Configuration

BUS:CPARallel:WIDTh.............................................................................................438

BUS:CPARallel:CLOCK:SLOPe.................................................................................438

BUS:CPARallel:CS:POLarity.....................................................................................438

BUS:CPARallel:WIDTh <BusWidth>

Sets the number of lines to be analyzed. D0 and D1 are reserved for chip select and

clock, all other digital channels can be used for data.

Suffix:

1..4

Selects the bus.

Note: SPI/SSPI and UART protocols occupy two bus lines.

Parameters:

<BusWidth> Range: 1 to 14

Increment: 1

*RST: 4

Default unit: Bit

BUS:CPARallel:CLOCK:SLOPe <ClockSlope>

Selects if the data is sampled on the rising or falling slope of the clock, or on both edges

(EITHer). The clock slope marks the begin of a new bit

Suffix:

1..4

Selects the bus.

Note: SPI/SSPI and UART protocols occupy two bus lines.

Parameters:

<ClockSlope> POSitive | NEGative | EITHer

BUS:CPARallel:CS:POLarity <Polarity>

Selects wether the chip select signal is high active (high = 1) or low active (low = 1).

Suffix:

1..4

Selects the bus.

Note: SPI/SSPI and UART protocols occupy two bus lines.

Command Reference

Rohde & Schwarz RTM2032 - Page 453