Rohde & Schwarz RTM2032 - Reference Waveforms

Remote Control
R&S
®
RTM20xx
322User Manual 1317.4726.02 ─ 01
Usage: Event
15.2.7 Reference Waveforms
For data queries and conversion, consider also the following commands:
● FORMat[:DATA] on page 278
● REFCurve<m>:DATA:XINCrement? on page 280
● REFCurve<m>:DATA:XORigin? on page 279
● REFCurve<m>:DATA:YINCrement? on page 280
● REFCurve<m>:DATA:YORigin? on page 280
● REFCurve<m>:DATA:YRESolution? on page 281
REFCurve<m>:STATe....................................................................................................322
REFCurve<m>:SOURce.................................................................................................322
REFCurve<m>:SOURce:CATalog?..................................................................................323
REFCurve<m>:UPDate..................................................................................................323
REFCurve<m>:SAVE.....................................................................................................323
REFCurve<m>:LOAD.....................................................................................................324
REFCurve<m>:LOAD:STATe..........................................................................................324
REFCurve<m>:HORizontal:SCALe..................................................................................324
REFCurve<m>:HORizontal:POSition................................................................................324
REFCurve<m>:VERTical:SCALe.....................................................................................325
REFCurve<m>:VERTical:POSition...................................................................................325
REFCurve<m>:DATA?...................................................................................................325
REFCurve<m>:DATA:HEADer?.......................................................................................325
REFCurve<m>:STATe
Displays or hides the selected reference waveform.
Suffix:
<m>
.
1..4
Selects the reference waveform, the internal reference storage.
Parameters:
<State> ON | OFF
*RST: OFF
REFCurve<m>:SOURce <Source>
Defines the source of the reference waveform.
Suffix:
<m>
.
1..4
Selects the reference waveform, the internal reference storage.
Command Reference