Rohde & Schwarz RTM2032 - Page 339

Remote Control
R&S
®
RTM20xx
324User Manual 1317.4726.02 ─ 01
REFCurve<m>:LOAD <FileName>
Loads the waveform data from the indicated reference file to the reference storage.
To load the instrument settings, use REFCurve<m>:LOAD:STATe.
Suffix:
<m>
.
1..4
Selects the reference waveform, the internal reference storage.
Setting parameters:
<FileName> String with path and file name
Usage: Setting only
REFCurve<m>:LOAD:STATe
Loads the instrument settings in addition to the reference waveform data. The waveform
data must be loaded before the settings, see REFCurve<m>:LOAD on page 324.
The settings are only available if the file was stored to the internal storage /INT/
REFERENCE and never written to an external storage (USB stick).
Suffix:
<m>
.
1..4
Selects the reference waveform.
Usage: Event
REFCurve<m>:HORizontal:SCALe <Scale>
Changes the horizontal scale (timebase) of the reference waveform independent of the
channel waveform settings.
Suffix:
<m>
.
1..4
Selects the reference waveform, the internal reference storage.
Parameters:
<Scale> *RST: 1,00E-004
Default unit: s/div
REFCurve<m>:HORizontal:POSition <Position>
Changes the horizontal position of the reference waveform independent of the channel
waveform settings.
Suffix:
<m>
.
1..4
Selects the reference waveform, the internal reference storage.
Parameters:
<Position> *RST: 0
Default unit: s
Command Reference